← All parts

0.96" OLED Display (SSD1306, I2C)

Display

Small, sharp 128x64-pixel OLED display that needs no backlight; over I2C it uses only two data pins. For showing sensor readings, menus and simple graphics. Used with the Adafruit SSD1306 or U8g2 library.

Specifications

Size

0.96 inch

Resolution

128 x 64 pixels

Driver

SSD1306

Colour

Monochrome (white, blue or yellow-blue)

Interface

I2C (address 0x3C, some 0x3D)

Supply voltage

3.3 - 5V

Current

~20 mA (depends on lit pixels)

Library

Adafruit SSD1306 / U8g2

Pins

VCC, GND, SCL, SDA

Shop prices

• RobocomboIn stock114.00 ₺
• Direnc.netIn stock162.73 ₺
• ElektrovadiIn stock180.36 ₺
• MotorobitIn stock202.00 ₺
• RobotistanIn stock217.11 ₺
• HatfonIn stock232.73 ₺
• Robolink MarketIn stock244.50 ₺
• RobotsepetiIn stock274.30 ₺
• SAMM MarketOut of stock157.27 ₺
• Robo90Out of stock160.70 ₺
• Modül ElektronikOut of stock186.38 ₺
• RobotzadeOut of stock270.00 ₺

Prices read from the shops' pages on 22 October 2026. Prices and stock may have changed since; check at the shop before you buy.

Projects with this part

• OLED Distance MeterIntermediate40 minA meter that shows the distance measured by an HC-SR04 on a 0.96" OLED screen, no computer needed: the distance in large text on top, and below it a bar graph of the last 128 readings scrolling to the right. Move your hand closer and further and watch the graph rise and fall. It teaches driving a screen over I2C, drawing text and lines with Adafruit GFX, keeping readings in a ring buffer, and timing with millis() instead of delay. Install the "Adafruit SSD1306" and "Adafruit GFX" libraries from the Library Manager.Open project
• Digital Spirit LevelIntermediate45 minA project that turns the breadboard itself into a spirit level: the MPU6050's accelerometer measures which way gravity pulls, and the Arduino works out the tilt on two axes in degrees. On the left of the OLED a bubble runs to the high side like in a real spirit level, and on the right the X and Y tilt are written; once both are under half a degree the screen says "LEVEL" and the buzzer gives two short beeps. It teaches using a sensor without a library by reading its registers directly, working out an angle from gravity (atan2), smoothing a jittery reading, and putting two I2C modules on one line. Install "Adafruit SSD1306" and "Adafruit GFX" from the Library Manager.Open project